二氟甲烷分子3a1和2b2轨道的电子动量谱

借助电子动量谱学结合量子化学理论和其他方法可以给出轨道电子在整个空间的分布信息,由此给出电子运动的完备描述[1,2 ] .清华大学电子动量谱学实验室近几年已成功地对甲烷[3] 、异丁烷[4 ] 、环戊烷[5] 、二乙酰等[6 ] 分子的轨道电子动量分布进行了测量.我们利用第二代电子动量谱仪首次对CH2 F2 分子3a1和2b2 轨道的电子动量谱进行测量,并与理论计算结果作了比较.同时还计算了坐标空间和动量空间中电子在x - y平面的密度分布.电子动量谱学最基本的过程是(e ,2e)反应,即电子与靶粒子碰撞而发生的电离过程.而对于(e ,2e)反应,含有大量信…     

旋光性与电光效应交互作用及其对旋光晶体电光Q开关的影响

研究了晶体的旋光性与电光效应的交互作用、以及此交互作用对 旋光晶体电光Q开关的影响. 关键词： 旋光性 电光效应 电光Q开关 3Ga₅SiO₁₄晶体')" href="#">La₃Ga₅SiO₁₄晶体     

二茂铁在高温热解乙二胺制备CN_x纳米管过程中的催化性能研究

采用高温热解法 ,以二茂铁 乙二胺有机溶剂为前驱液制备CNx 纳米管过程中 ,改变前驱液配比 ,对 86 0℃ ,不同二茂铁含量条件下制备出的CNx 纳米管进行了产量统计、形貌结构观察和拉曼光谱研究。结果显示 :随着前躯液中二茂铁含量的相对增大 ,不但CNx 纳米管产量随之增加 ,而且产物中“竹节状”结构纳米管相对“中空”结构纳米管的比重也增大 ;拉曼光谱结果进一步证实了由于“竹节状”结构CNx 纳米管的含量或比重增加所带来的纳米管样品整体或平均含氮量的升高而导致的样品结晶有序程度的降低。对单独钴粉和二茂铁催化条件下生成CNx 纳米管的形貌观察进一步证实 :二茂铁在热解法制备“竹节状”结构CNx 纳米管过程中的浮动催化作用显著 ,有利于实现含氮量较高、结构均匀的CNx 纳米管的可控制生长。     

含氮类金刚石薄膜的紫外辐照研究

 用射频等离子体方法在玻璃基底上制备的类金刚石（DLC）薄膜，采用离子注入法掺氮，并对掺氮DLC薄膜紫外（UV）辐照前后的性能变化进行了研究。研究结果表明：随氮离子注入剂量及UV辐照时间的增加，位于2 930cm^-1附近的SP ³C-H吸收峰明显变小，而位于1 580cm^-1附近的SP2C-H吸收峰则明显增强，薄膜的电阻率明显呈下降趋势；随UV辐照时间的增加，位于1 078cm^-1附近的Si-O-Si键数量及位于786cm^-1附近的Si-C键数量明显增加。即氮离子注入和UV辐照明显改变了DLC薄膜的结构与特性。     

Optimization of Mass Transfer Processes in the Zone of the Air Electrode of a Fuel Cell with a Solid Polymer Electrolyte

A two-dimensional mathematical model for the transport of reactants in a fuel cell with a solid polymer electrolyte is developed. The model is used for analyzing spatial distributions of the concentration of reactants and current density over the cell. The effect of the catalytic-layer activity, reactant speed, bipolar-plate geometry, thickness and porosity of current collector and/or gas-diffusion sublayer, and the reaction mixture composition on the fuel cell efficiency is estimated theoretically and experimentally.     

Microwave-accelerated conjugate addition of aldehydes to α,β-unsaturated ketones

Aldehydes undergo smooth conjugate addition to α,β-unsaturated ketones in the presence of 5-(2-hydroxyethyl)-1,3-thiazolium halides and DBU adsorbed onto the surface of basic alumina under microwave irradiation and solvent-free conditions to afford 1,4-diketones in enhanced yields and reduced reaction times compared to conventional methods.     

两相同部件温贮备可修的人机系统解的性质分析

本文首先用强连续算子半群理论证明了两相同部件温贮备可修的人机系统动态非负解的存在唯一性 ,然后证明了 0是系统主算子的本征值 ,并得到 0本征值对应的本征向量是正的 ,从而系统存在稳态正解 .     

Hydroxylation-induced modifications of the Al2O3/NiAl(0 0 1) surface at low water vapour pressure

STM, STS, LEED and XPS data for crystalline θ-Al₂O₃ and non-crystalline Al₂O₃ ultra-thin films grown on NiAl(0 0 1) at 1025 K and exposed to water vapour at low pressure (1 × 10⁻⁷-1 × 10⁻⁵ mbar) and room temperature are reported. Water dissociation is observed at low pressure. This reactivity is assigned to the presence of a high density of coordinatively unsaturated cationic sites at the surface of the oxide film. The hydroxyl/hydroxide groups cannot be directly identify by their XPS binding energy, which is interpreted as resulting from the high BE positions of the oxide anions (O_1s signal at 532.5-532.8 eV). However the XPS intensities give evidence of an uptake of oxygen accompanied by an increase of the surface coverage by Al³⁺ cations, and a decrease of the concentration in metallic Al at the alloy interface. A value of ∼2 for the oxygen to aluminium ions surface concentration ratio indicates the formation of an oxy-hydroxide (AlO_xOH_y with x + y ∼ 2) hydroxylation product. STM and LEED show the amorphisation and roughening of the oxide film. At P(H₂O) = 1 × 10⁻⁷ mbar, only the surface of the oxide film is modified, with formation of nodules of ∼2 nm lateral size covering homogeneously the surface. STS shows that essentially the valence band is modified with an increase of the density of states at the band edge. With increasing pressure, hydroxylation is amplified, leading to an increased coverage of the alloy by oxy-hydroxide products and to the formation of larger nodules (∼7 nm) of amorphous oxy-hydroxide. Roughening and loss of the nanostructure indicate a propagation of the reaction that modifies the bulk structure of the oxide film. Amorphisation can be reverted to crystallization by annealing under UHV at 1025 K when the surface of the oxide film has been modified, but not when the bulk structure has been modified.     

Local adsorption sites and bondlength changes in Ni(1 0 0)/H/CO and Ni(1 0 0)/CO

The local adsorption geometry of CO adsorbed in different states on Ni(1 0 0) and on Ni(1 0 0) precovered with atomic hydrogen has been determined by C 1s (and O 1s) scanned-energy mode photoelectron diffraction, using the photoelectron binding energy changes to characterise the different states. The results confirm previous spectroscopic assignments of local atop and bridge sites both with and without coadsorbed hydrogen. The measured Ni–C bondlengths for the Ni(1 0 0)/CO states show an increase of 0.16 ± 0.04 Å in going from atop to bridge sites, while comparison with similar results for Ni(1 1 1)/CO for threefold coordinated adsorption sites show a further lengthening of the bond by 0.05 ± 0.04 Å. These changes in the Ni–CO chemisorption bondlength with bond order (for approximately constant adsorption energy) are consistent with the standard Pauling rules. However, comparison of CO adsorbed in the atop geometry with and without coadsorbed hydrogen shows that the coadsorption increases the Ni–C bondlength by only 0.06 ± 0.04 Å, despite the decrease in adsorption energy of a factor of 2 or more. This result is also reproduced by density functional theory slab calculations. The results of both the experiments and the density functional theory calculations show that CO adsorption onto the Ni(1 0 0)/H surface is accompanied by significant structural modification; the low desorption energy may then be attributed to the energy cost of this restructuring rather than weak local bonding.     

Distribution results for lattices in SL(2,ℚ p )

In this paper we study the ergodic properties of the linear action of lattices Γ of SL(2,ℚ_p) on ℚ_p × ℚ_p and distribution results for orbits of Γ. Following Serre, one can define a “geodesic flow” for an associated tree (actually associated to GL(2,ℚ_p)). The approach we use is based on an extension of this approach to “frame flows” which are a natural compact group extension of the geodesic flow.